Will lifting front only by 2" on my 04 RWD Affect pinion ?


Topic author
Vanboozin
I am smitten with my van
Posts: 29
Joined: Tue Dec 04, 2012 8:41 pm
Location: Gibsons B.C.

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by Vanboozin »

Since lifting the front i now have a rumble/vibration at idle and low speed, turning around etc. only while in gear ? Once i get moving faster its not as noticable.
Any ideas ?
It was not there before the lift.
User avatar

doyoulikeithere
ASV Supporter
ASV Supporter
Posts: 2060
Joined: Tue Nov 17, 2009 8:27 pm
Location: Misty Mountains of Cowichan BC.

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by doyoulikeithere »

what kind of lift?
body blocks?
2021 Yamaha Tenere 700 - Blue.
2016 Yamaha XSR900 - Silver.
1990 Astro - AWD - Brown.
1987 Astro - With 5 Speed & 4wd - Silver & Blue.

Topic author
Vanboozin
I am smitten with my van
Posts: 29
Joined: Tue Dec 04, 2012 8:41 pm
Location: Gibsons B.C.

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by Vanboozin »

Yes 2" body pucks and overland bumper brackets
User avatar

MountainManJoe
I have my van tatooed on my cheeks
Posts: 3088
Joined: Fri Aug 08, 2008 12:55 pm
Location: The Pacific North Wet
Has thanked: 44 times
Been thanked: 24 times

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by MountainManJoe »

That could be two things. Make sure the tailpipe isn't touching the springs. If not, it's probably your pinion angle, and the fix is to shim it, or adjust rear spring height.

viewtopic.php?f=5&t=6498&p=65720
User avatar

thegreenmachine
I get chills without my van.
Posts: 81
Joined: Sun Oct 03, 2010 9:50 am
Location: chilliwack B.C.

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by thegreenmachine »

I was under the impression that a body lift shouldn't affect pinion angle as the subframe that hold the motor and trans is effectively in the same spot it was prior to moving the body up 2".

swapping springs, or lift blocks in the rear will affect pinion angle as your moving the axel down, thus changing the driveshaft angle.

I believe that is the difference between a suspension lift, and body lift I believe. Our vans are a half and half. body lift via pucks up front, suspension lift via springs or blocks in the rear

could be wrong though.
shane
2003 Chevrolet Astro 4wd np233c transfercase 245/75/16 ETS Trailermaster tires
ImageImageImage
Previous:
1995 Safari AWD (death by torsion bar. a.k.a. "the final straw")
1999 Safari AWD ( death by tree x2 )
1997 safari rwd cargo ( sold @ 450,000+ km )
User avatar

MountainManJoe
I have my van tatooed on my cheeks
Posts: 3088
Joined: Fri Aug 08, 2008 12:55 pm
Location: The Pacific North Wet
Has thanked: 44 times
Been thanked: 24 times

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by MountainManJoe »

The pucks move the body away from the subframe. The rear axle is connected to the body and the driveshaft is connected to the subframe, so the angle must change. Only an angle finder will tell you for sure. Some higher springs might have been a better investment.
User avatar

mdmead
ASV Supporter
ASV Supporter
Posts: 2153
Joined: Sun Sep 10, 2006 6:45 pm
Location: Selah, WA
Been thanked: 1 time
Contact:

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by mdmead »

While dropping the front lessened the angle of the driveshaft, you also shortened the needed length of the shaft. Worst case is your driveshaft could now be too long and is causing problems at the transmission end where it slips in. Probably not, but something to consider.

I think I might just play with some axle shims and see what that does for you. While things are supposed to work a certain way on paper, they don't always seem to cooperate in the real world. You may find a slight tweak of the pinion angle fixes this.
Matt
Selah, WA
-96 GMC Safari AWD Hi-Top Conversion -->Stalled 5.3L swap & 5" lift
-74 Ford Bronco -->Far from perfect but mine!
-99 V-10 Ford Super Duty Super Cab 4x4 -->Stock with 285 Cooper ATs
-00 Ford Focus Wagon -->The Red Turd
-95 Ford 24' Class C Motorhome -->My big block sleeper
-07 Can-Am Outlander XT -->My yellow 4x4 quad for work & play
-04 Ski Doo REV Summit -->Still several chassis behind!


No new projects until the current ones are done!
User avatar

thegreenmachine
I get chills without my van.
Posts: 81
Joined: Sun Oct 03, 2010 9:50 am
Location: chilliwack B.C.

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by thegreenmachine »

timelessbeing wrote:The pucks move the body away from the subframe. The rear axle is connected to the body and the driveshaft is connected to the subframe, so the angle must change. Only an angle finder will tell you for sure. Some higher springs might have been a better investment.
based on my knowledge of trigonometry, and angles, (I'm a carpenter, angles are kind of my thing) I cant see a 2 inch rise of the front of the van changing an angle at the tires by very much, as the changes decreases closer to the pivot point, i.e. the axel, maybe a millimeter, in which case I wouldn't call that a big change, like .025 of a degree, but when you lift anything you are messing with a a bunch of angles, not meant to be changed, body lifts are the only way keep stock suspension specs, while gaining room for bigger tyres.

its like saying its only like 1/8 of an inch out of level.
An 1/8 out of level over 4 feet translates to 5/8's over 20 feet

maybe get some 1 deg shims throw them in and see if it changes, if it gets better, leave it, If it gets worse, take them out.

check your u joints, pinion nut, and diff fluid. too if no one else has mentioned that.......
2003 Chevrolet Astro 4wd np233c transfercase 245/75/16 ETS Trailermaster tires
ImageImageImage
Previous:
1995 Safari AWD (death by torsion bar. a.k.a. "the final straw")
1999 Safari AWD ( death by tree x2 )
1997 safari rwd cargo ( sold @ 450,000+ km )
User avatar

MountainManJoe
I have my van tatooed on my cheeks
Posts: 3088
Joined: Fri Aug 08, 2008 12:55 pm
Location: The Pacific North Wet
Has thanked: 44 times
Been thanked: 24 times

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by MountainManJoe »

2" over 4' is a difference of 2.4 degrees.

LiftedAWDAstro
I have my van tatooed on my cheeks
Posts: 4379
Joined: Sat Sep 09, 2006 3:35 pm
Location: New Haven, NY

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by LiftedAWDAstro »

I would definitely check pinion angle in relation to the transmission output. They need to be within 0.5 degree of each other or you will get vibrations.
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition

Mileage spreadsheet

Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy

claudconger
I am merely driving my van
I am merely driving my van
Posts: 3
Joined: Fri Sep 12, 2014 4:25 am
Location: Crystal Beach, TX
Contact:

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by claudconger »

I just purchase an 04 awd cargo van. It's in great shape, only 45,000 miles on it. It was previously owned by the water utility company, I don't know if that's a good thing or a bad thing. I am planning on doing a little work on it to make it it into a camper. Thinking about installing a 2" lift also. My question is regarding the stock existing suspension on my van. The back looks like it is already at least a couple inches higher than the front. Is that how the stock suspension is set up or did someone modify it, perhaps to accommodate heavy cargo?
User avatar

Stroverlander
I sleep in my van
Posts: 308
Joined: Fri Dec 16, 2011 4:18 pm

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by Stroverlander »

It may have heavy duty leaf springs (how many leafs in each?) and/or sagging torsion bars which can be adjusted to even out ride height.
2004 Astro LT AWD Stroverlander
User avatar

mdmead
ASV Supporter
ASV Supporter
Posts: 2153
Joined: Sun Sep 10, 2006 6:45 pm
Location: Selah, WA
Been thanked: 1 time
Contact:

Re: Will lifting front only by 2" on my 04 RWD Affect pinion

Post by mdmead »

claudconger wrote:I just purchase an 04 awd cargo van. It's in great shape, only 45,000 miles on it. It was previously owned by the water utility company, I don't know if that's a good thing or a bad thing. I am planning on doing a little work on it to make it it into a camper. Thinking about installing a 2" lift also. My question is regarding the stock existing suspension on my van. The back looks like it is already at least a couple inches higher than the front. Is that how the stock suspension is set up or did someone modify it, perhaps to accommodate heavy cargo?
My guess is it is factory stock. The last new vans I saw sold out of the local Chevy dealer all had the butts sitting unusually high (when compared to my stock '96).
Matt
Selah, WA
-96 GMC Safari AWD Hi-Top Conversion -->Stalled 5.3L swap & 5" lift
-74 Ford Bronco -->Far from perfect but mine!
-99 V-10 Ford Super Duty Super Cab 4x4 -->Stock with 285 Cooper ATs
-00 Ford Focus Wagon -->The Red Turd
-95 Ford 24' Class C Motorhome -->My big block sleeper
-07 Can-Am Outlander XT -->My yellow 4x4 quad for work & play
-04 Ski Doo REV Summit -->Still several chassis behind!


No new projects until the current ones are done!
Post Reply