Rear barn door interior release mechanism

FROM HEADLINERS TO CARPETS, CUSTOM DASHES TO MOOD LIGHTING, IT GOES HERE.
Post Reply

Topic author
LiftedAWDAstro
I have my van tatooed on my cheeks
Posts: 4379
Joined: Sat Sep 09, 2006 3:35 pm
Location: New Haven, NY

Rear barn door interior release mechanism

Post by LiftedAWDAstro »

My rear doors have been stuck closed for a month or so and I figured I better fix it now before the cold weather gets here. Crawled inside and pulled the door panel open enough to get my hand in to pull the release. Now to see why.

Pulled the trim panel completely off including the speaker grill to release the carpet panel.

Image

Image

Found the linkage simply came off the handle trip. Plugged it in and it works! Now to eliminate that from happening again. I pulled the latch mechanism out by removing the 4 T-30 torx bolts. I also had to release the opener and lock pull rods.

Image

You end up with this:

Image

Now I drilled a couple holes in the arms. The one on the left is for the lock and the right one is the latch release. In the latch release, I installed the plastic bushing and a test linkage. The plastic bushing was removed from the key lock mechanism. This has been frozen since I bought the van.

Image

Image
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition

Mileage spreadsheet

Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy

Topic author
LiftedAWDAstro
I have my van tatooed on my cheeks
Posts: 4379
Joined: Sat Sep 09, 2006 3:35 pm
Location: New Haven, NY

Re: Rear barn door interior release mechanism

Post by LiftedAWDAstro »

Now to make a handle to lock/unlock in case the power actuator dies. Found a copper wire lug I had lying around and straightened it out.

Image

Image

Put a small #10 bolt in it:

Image

Image

Installed the latch mechanism back into the door and marked a couple spots for the new release linkages to come through. Didn't get a pic as the camera batteries died before I got new ones. Once these holes were drilled, I installed the lug on the bolt and bolted that with a lock nut to the lock release arm. You need to keep it loose enough to allow free movement.

Image

Image

Image

I then cut 4.5" of the linkage from the key lock since it was just hanging there. I then installed that into the new hole with plastic bushing in the latch release arm. You can just see it going up.

Image

Here they are poking through the door:

Image

And finished off:

Image

The one on the right with the 90 degree bend is the door opener...just push down! The other is the lock. Down for lock, up for unlock.

Image
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition

Mileage spreadsheet

Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy
User avatar

CaptSquid
I plan to be buried in my van
Posts: 1230
Joined: Sun Sep 10, 2006 4:50 am
Location: Billings, MT, 'MERICA!

Re: Rear barn door interior release mechanism

Post by CaptSquid »

Nicely done, excellent write-up and so-so pictures :poke: . But one question begs to be asked...

What are these "barn doors" of which you speak? :poke: :poke:
Mike, Billings, MT, 'MERICA!
92 Safari SLE w/Z Motor (sold to a good home)
98 AWD Stro LS
93 Suburban Silverado 4x4

Look for the MISSING Alien in the Right Seat. AL, PHONE HOME!!!

ImageImage
Image

infinite.chris
I get chills without my van.
Posts: 90
Joined: Fri Feb 10, 2012 10:46 pm
Location: Holland, Ohio

Re: Rear barn door interior release mechanism

Post by infinite.chris »

I always kinda felt this is how the vans, both cargo and passenger, should have came, stock.

Excellent encouragement to free up my lock cylinder in the back, as of late it only unlocks via the main door unlock!
[SCRUFFY 95 RWD Astro Cargo :: 227k ]

------------------------------------------------

astrozam
I have my van tatooed on my cheeks
Posts: 2770
Joined: Fri Sep 08, 2006 2:57 am
Has thanked: 1 time
Been thanked: 2 times

Re: Rear barn door interior release mechanism

Post by astrozam »

Good stuff Deano :cheers:

neppi
I am merely driving my van
I am merely driving my van
Posts: 7
Joined: Mon Jan 23, 2012 12:13 pm

Re: Rear barn door interior release mechanism

Post by neppi »

Here's my solution. Inside the door it's about the same as 'Lifted':s. The pic's look crappy, but in real life the thing's looking quite all right.

Parts from 89 Toyota Starlet, the mushroom-like from the rear seat backrest and the square-one from the door.

Easy mod and upgrades the original 100%.

Neppi
Attachments
image.jpg
image.jpg
Last edited by neppi on Mon Dec 31, 2012 7:57 am, edited 1 time in total.
User avatar

Smiliesafari
ASV Supporter
ASV Supporter
Posts: 2667
Joined: Sat Dec 02, 2006 12:34 pm
Location: Orlando, FL

Re: Rear barn door interior release mechanism

Post by Smiliesafari »

Good job, guys. Another mod I should do. Dean, still waiting for an update on the S 10 cluster mod.
1996 Safari SLX Hotair balloon transport vehicle

Topic author
LiftedAWDAstro
I have my van tatooed on my cheeks
Posts: 4379
Joined: Sat Sep 09, 2006 3:35 pm
Location: New Haven, NY

Re: Rear barn door interior release mechanism

Post by LiftedAWDAstro »

Smiliesafari wrote:Dean, still waiting for an update on the S 10 cluster mod.
Possibly this week. Gotta get the transfer case done first and it's supposed to be single digits!
Current rides:
2013 Toyota Tundra DC 4x4
2008 Dodge Nitro 4x4
2005 Nissan Sentra 1.8S Special Edition

Mileage spreadsheet

Vans owned:
1986 Safari 2.5L 4 speed manual - scrapped
1995 Astro 2WD conversion 4.11 posi, shift kit, DHC rock rails - sold to Skippy
1998 Astro 4x4 D44, D60, NP231, full hydraulic system with 9k# Milemarker winch and snow plow - sold to Lockdoc
2003 Astro AWD all stock - traded for a 3/4 ton truck
2005 AWD, 4.10's - sold to skippy
Post Reply