Flushing cooling system

FROM RADIATORS TO THERMOSTATS TO HEATER CORES, IT GOES HERE.

Moderator: LiftedAWDAstro

astroturf
ASV Supporter
ASV Supporter
Posts: 1692
Joined: Thu Sep 10, 2009 1:25 am
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by astroturf » Tue Oct 19, 2010 9:53 pm

I don't think so.

I just routed mine around the front heater core hoses to give me that windshield cracking heated fluid in the winter.

It works pretty good too.

Jim

User avatar
timelessbeing
Site Admin
Site Admin
Posts: 2715
Joined: Fri Aug 08, 2008 7:55 pm
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by timelessbeing » Tue Oct 19, 2010 10:42 pm

That's a good idea.

My nozzles get jammed up in the winter.

User avatar
timelessbeing
Site Admin
Site Admin
Posts: 2715
Joined: Fri Aug 08, 2008 7:55 pm
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by timelessbeing » Wed Oct 20, 2010 4:02 pm

OK I finished the job last night, and came up with a very quick and easy way to flush out the entire cooling system, including rear heater! No cutting lines, no special adapters, and you only need to disconnect one hose. It goes something like this:
  • I took out the intake and washer fluid/coolant reservoir just to have room to work.
  • Disconnect the the main heater return hose (it's the smaller diameter one of the two) from the valve assembly, and plug it. I stuck a cork in it, and put a hose clamp over it. I'm sure folding it over and putting a vice-grip on it will work just as well.
  • Start the engine, and turn on your rear heat
  • Continuously supply fresh water into radiator neck, until the water coming out of the valve assembly runs clear.
  • Unplug the heater hose, and turn off the rear heat. Repeat step #4
  • Now stop filling the radiator and wait until water stops flowing. Turn off engine.
  • Replace heat hose. Pour two jugs of coolant into radiator. It should just fit. Done!
One job down, about 6 more to go.

kkamakasi
I am smitten with my van
Posts: 38
Joined: Thu Dec 02, 2010 5:11 am
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by kkamakasi » Sat Dec 04, 2010 2:43 am

timelessbeing wrote:OK I finished the job last night, and came up with a very quick and easy way to flush out the entire cooling system, including rear heater! No cutting lines, no special adapters, and you only need to disconnect one hose. It goes something like this:
  • I took out the intake and washer fluid/coolant reservoir just to have room to work.
  • Disconnect the the main heater return hose (it's the smaller diameter one of the two) from the valve assembly, and plug it. I stuck a cork in it, and put a hose clamp over it. I'm sure folding it over and putting a vice-grip on it will work just as well.
  • Start the engine, and turn on your rear heat
  • Continuously supply fresh water into radiator neck, until the water coming out of the valve assembly runs clear.
  • Unplug the heater hose, and turn off the rear heat. Repeat step #4
  • Now stop filling the radiator and wait until water stops flowing. Turn off engine.
  • Replace heat hose. Pour two jugs of coolant into radiator. It should just fit. Done!
One job down, about 6 more to go.
This may be a dumb question but Astro Cargo doesn't have a rear heater right? Since it's a cargo?

User avatar
timelessbeing
Site Admin
Site Admin
Posts: 2715
Joined: Fri Aug 08, 2008 7:55 pm
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by timelessbeing » Sun Dec 05, 2010 1:18 am

I don't know, but one quick look behind the driver seat will tell you right away.

I believe C36 is the RPO code for auxiliary heater.

kkamakasi
I am smitten with my van
Posts: 38
Joined: Thu Dec 02, 2010 5:11 am
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by kkamakasi » Sun Dec 05, 2010 4:40 am

timelessbeing wrote:I don't know, but one quick look behind the driver seat will tell you right away.

I believe C36 is the RPO code for auxiliary heater.
what's behind the driver seat?

User avatar
snapple
ASV Supporter
ASV Supporter
Posts: 378
Joined: Wed Jan 16, 2008 1:20 am
antispam: No
How many wheels are on an Astro van? (4): 4
Location: Ithaca,NY area

Re: Flushing cooling system

Post by snapple » Sun Dec 05, 2010 4:51 am

kkamakasi wrote:
timelessbeing wrote:I don't know, but one quick look behind the driver seat will tell you right away.

I believe C36 is the RPO code for auxiliary heater.
what's behind the driver seat?
There will be a heat vent there. Also you would have a separate heat controller on your dash for the rear ,if you have a rear heater. At least that is how my '94 is.
'94 Astro AWD EXT LT - Over 211,000 ,parts van now!
DHC Rock rails
Overland Vans 4" lift kit and bumper w/grille guard
Fiamma awning

'95 Astro AWD EXT CS - Just over 99,000 miles

kkamakasi
I am smitten with my van
Posts: 38
Joined: Thu Dec 02, 2010 5:11 am
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by kkamakasi » Sun Dec 05, 2010 4:55 am

snapple wrote:
kkamakasi wrote:
timelessbeing wrote:I don't know, but one quick look behind the driver seat will tell you right away.

I believe C36 is the RPO code for auxiliary heater.
what's behind the driver seat?
There will be a heat vent there. Also you would have a separate heat controller on your dash for the rear ,if you have a rear heater. At least that is how my '94 is.
I only see one set of temperature controls in my astro cargo. I guess that means I dont have a second heater. Less work for me I guess when I flush the system. Thanks!

photo_van
I sleep in my van
Posts: 590
Joined: Wed May 18, 2011 11:38 pm
antispam: No
How many wheels are on an Astro van? (4): 4
Location: 7000' in the Mountains of California

Re: Flushing cooling system

Post by photo_van » Sat Aug 27, 2011 1:22 am

I just flushed my system today using the Timeless One's method; this is by far the best method I have seen anywhere. No cutting the heater hose for a tee (and getting the Squid all wiggly) and no crawling under trying to get that dang lower hose off and having it pour all over everywhere. The only thing I'd add is that a garden hose fits perfectly over the heater core tube, no clamp necessary, and you just run that into a bucket. Very clean. Also, I refilled with water, ran it hot, then repeated. Kudos to Timeless =D>

This method really should be stickyed. It didn't seem like I was going to be able to get 2 gal of AF back in there, so I blew back on the heater return hose a few times which flushed additional water out of the radiator fill neck. Lastly, it took running the engine hot (to remove air) before I could get close to 2 gallons of antifreeze in.
timelessbeing wrote: [*]I took out the intake and washer fluid/coolant reservoir just to have room to work.
[*]Disconnect the the main heater return hose (it's the smaller diameter one of the two) from the valve assembly, and plug it. I stuck a cork in it, and put a hose clamp over it. I'm sure folding it over and putting a vice-grip on it will work just as well.
[*]Start the engine, and turn on your rear heat
[*]Continuously supply fresh water into radiator neck, until the water coming out of the valve assembly runs clear.
[*]Unplug the heater hose, and turn off the rear heat. Repeat step #4
[*]Now stop filling the radiator and wait until water stops flowing. Turn off engine.
[*]Replace heat hose. Pour two jugs of coolant into radiator. It should just fit. Done![/list]
1998 AWD/4WD
4" lift, 31x10.50's, NP 242j/c hybrid, 4.10 gears, S10 front disconnect, rack & pinion steering, trans cooler, rock sliders, ARB fridge, house battery and 100w solar, swing out rear rack with foldout camp table, bed and passenger swivel chair
dirt bag camping rig
1981 Toyota 4x4 pu
1974 John Deere 710
Image

User avatar
timelessbeing
Site Admin
Site Admin
Posts: 2715
Joined: Fri Aug 08, 2008 7:55 pm
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by timelessbeing » Thu Sep 01, 2011 5:52 am

If you liked this, you may also like my tranny flush procedure...
viewtopic.php?f=57&t=6356&p=66780#p66780

Let me know if the images don't show up for you.

User avatar
gotmud
I am merely driving my van
I am merely driving my van
Posts: 7
Joined: Sat Sep 17, 2011 4:25 am
antispam: No
How many wheels are on an Astro van? (4): 4
Location: Buckeye by birth, Sun Devil by location

Re: Flushing cooling system

Post by gotmud » Sun Oct 09, 2011 3:31 am

I think Timeless has some great instructions there. My only question after reading everyone's posts on this topic...why doesn't anyone drain the block? Without draining it, you'll still have regular tap water in the system when you get ready to put the anitifreeze and distilled water in.

User avatar
timelessbeing
Site Admin
Site Admin
Posts: 2715
Joined: Fri Aug 08, 2008 7:55 pm
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by timelessbeing » Sun Oct 09, 2011 3:34 am

Over time, the antifreeze will mix with the water to reach your desired proportion. If you don't do this in the winter, you don't have to worry about anything freezing. I have always used tap water without issue.

Cobra
ASV Supporter
ASV Supporter
Posts: 1764
Joined: Sat Jun 16, 2007 9:31 pm
How many wheels are on an Astro van? (4): 6
Location: Toronto, Ontario

Re: Flushing cooling system

Post by Cobra » Mon Oct 10, 2011 9:04 pm

i think gotmud isn't so worried about the mixture as the chemicals in the tap water that can promote corrosion and other side effects inside the engine that's why the distilled water is important. I can only think of not too concerned about it or just plain lazy to be honest i don't even know how to drain a 4.3 :peep:
1998 GMC Safari AWD, BFGoodrich AllTerrain T/A
Jet performance tuner 91 octane preset, Jet under-drive pulleys
Rancho 999000 series shock, on-board controller to be installed later
DHC rock rails and skid plate Add-A-Leaf
G3500 front calipers
Zexel Torsen Diff
11" drums
180 amp Alternator
Long tru-cool 4590 trans cooler

1997 in storage (project coming soon)
1992 Chevy Astro "Z" vin (engine/trans in storage body crushed)
1995 Chevy Astro need lots of help project vehicle

brokenwrench
I finally get the smurf thing
Posts: 154
Joined: Tue Aug 16, 2011 3:35 am
antispam: No
How many wheels are on an Astro van? (4): 4

Re: Flushing cooling system

Post by brokenwrench » Tue Oct 11, 2011 12:23 am

Cobra wrote:i think gotmud isn't so worried about the mixture as the chemicals in the tap water that can promote corrosion and other side effects inside the engine that's why the distilled water is important. I can only think of not too concerned about it or just plain lazy to be honest i don't even know how to drain a 4.3 :peep:

do you drink that corrosive tap water?,

Cobra
ASV Supporter
ASV Supporter
Posts: 1764
Joined: Sat Jun 16, 2007 9:31 pm
How many wheels are on an Astro van? (4): 6
Location: Toronto, Ontario

Re: Flushing cooling system

Post by Cobra » Tue Oct 11, 2011 1:37 am

the water at work is bad enough to upset your stomach my water is filtered :D
don't underestimate what is in the cities tap water
1998 GMC Safari AWD, BFGoodrich AllTerrain T/A
Jet performance tuner 91 octane preset, Jet under-drive pulleys
Rancho 999000 series shock, on-board controller to be installed later
DHC rock rails and skid plate Add-A-Leaf
G3500 front calipers
Zexel Torsen Diff
11" drums
180 amp Alternator
Long tru-cool 4590 trans cooler

1997 in storage (project coming soon)
1992 Chevy Astro "Z" vin (engine/trans in storage body crushed)
1995 Chevy Astro need lots of help project vehicle

Post Reply