Chevy & GMC Vans

I need to source a front sway bar bushing and link bushing kit. Would like to go with ac delco if possible

AWD swaybar is 30mm and after I cranked torsion bars the Moog Problem solver end links and bushings didn't hold up that well so I went with Energy Suspension 9.5171 30mm (1 3/16") greasable bushing kit and longer 9.8167 Adjust-A-Link end links that come with two size bushings so I could fine tune the fit to make the swaybar parallel with the lower control arm angle from torsion lift.







Rock Auto is probably a good starting point for AC Delco replacements though. Factory torque setting is 13 lb ft on the end link hardware so don't reef too much and crush the bushings.

Thanks. I liked your set up so I ordered the same. Looks like a lot better quality.

You're welcome. Do you have any torsion lift? If not, the end links may be a bit long but you could always cut them down.

I wrapped a bit of teflon tape (yellow gas) around the swaybar and greased with Super Lube w/Syncolon grease I ordered from Napa for polyurethane bushings. The tape supposedly helps prevent any squeaking, not sure it's really necessary though...

Yes torsion bars, reindexed keys and some lift

Great, should work well for you then!